Brother PC 3000 - Manual (Page 78)

75
1
CAUTION
Stitch width
Adjust the stitch width. Turn the balance wheel to check the nee-
dle clearance, so that the needle does not hit the needle plate.
Stitch length
•
Straight 2 mm min.
• Others 0.5 mm min.
Types of thread
Cotton thread or span thread are recommended because syn-
thetic threads may break.
5. Thread through remaining points, making certain to omit the
thread guide above the needle and pass thread through right
eye of needle.
1 The thread for the right needle should pass in front of
thread guide.
4. Set the extra spool pin into the hole on the end of the bobbin
winder shaft on the top of the machine. Follow the instructions
for single-needle threading.
1 Extra spool pin for right needle threading.
2 Push the spool pin securely into place.
6
1
5
2