Brother PC 3000 - Manual (Page 42)

39
OVERCASTING (WHEN USING THE OPTIONAL SIDE CUTTER)
00: Normal sewing
05: Zigzag stitch
06: Thin and medium fabrics
07: Thick fabric
08: Thick and medium stretch fabrics
By using the side cutter, you can do overcasting
while cutting the fabric.
1. Push the “NEEDLE POSITION” button to raise
the needle, and then turn off the power.
2. Raise the presser foot lever.
3. Unscrew screw on the presser foot holder and
remove the presser foot holder.
4. Set the screw of the needle into the fork of the
operating lever.
1 Screw of the needle
2 Operating lever
3 Notch
* Make sure that the needle clamp screw is held
firmly by the fork.
5. With the presser foot raised, align the presser
foot holder screw hole directly with the notch in
the side cutter, then insert the screw and lightly
tighten it. Lower the presser foot lever and firmly
tighten the screw.
06 07 08 05 00
5
2
3
5
1
6
5
6