Presser foot, Changing the presser foot – Brother PC 3000 User Manual

Page 27

PRESSER FOOT

Changing the presser foot

1. Press the “NEEDLE POSITION” button to raise the needle,

and then turn off the power.

2. Raise the presser foot lever.

3. Press the black button located at the back of the presser foot

holder to release the foot.

1 Presser foot holder

4. Place the presser foot pin directly below the holder-end and

lower the presser foot lever to attach the presser foot.

1 Holder-end
2 Foot pin

Loosen the presser foot holder screw, then pull the presser foot
holder down to remove it.

Note
When reattaching the presser foot holder, first attach the presser
foot to the presser foot holder. Then, lower the presser foot lever,
install the presser foot holder and securely tighten the presser
foot holder screw. The thread tension may be inaccurate if the
presser foot holder is incorrectly attached.

1 Disc-shaped screwdriver

Removing the presser foot holder (while cleaning, etc.)