Brother PC 3000 User Manual

Page 17

4. Align the groove in the bobbin with the spring on the shaft and

place the bobbin on the bobbin winder shaft. Then, push the
bobbin winder shaft to the right.

1 Spring on the shaft
2 Groove of the bobbin

5. Wind the thread clockwise around the bobbin four or five times,

pass the end of the thread through the slit in the bobbin winder
seat, and then pull the thread in the direction shown in the
illustration. Use the cutter to cut the thread.

1 Bobbin winder seat

6. Slide the speed range control lever to its maximum (as far to

the right as possible).

7. Press the “START/STOP” button. The machine will stop auto-

matically when the bobbin is full.

8. After the bobbin has stopped moving, press the “START/STOP”

button to stop the machine.

9. Cut the thread, slide the bobbin winder shaft to the left and

remove the bobbin.

Note
Immediately after winding the bobbin, it is normal to hear the sound
of the clutch engaging when beginning to sew or manually turning
the balance wheel.

3. Pass the thread through the thread guide as shown by the

arrows.