Brother PC 3000 - Manual (Page 18)

15
1
2
Setting the bobbin
1. Slide open the bobbin cover.
1 Bobbin cover
2 Bobbin cover release button
2. Insert the bobbin into the shuttle with the thread direction as
shown in the diagram.
3. Guide the thread end through the slit, then pull the thread to-
ward you to cut off any excess thread.
1 Built-in thread cutter
4. Close the bobbin cover by placing the left end in place and
pressing down lightly on the right end so that it snaps into
place.
* You can begin sewing immediately without drawing up the bob-
bin thread.
1
2
1