Brother PC 3000 - Manual (Page 67)

64
FLAT FELL SEAM
1. Attach presser foot “J”. Sew the seam line, then cut half of the
seam allowance from the side that the flat fell seam will lie
against.
1 About 1.2 cm (1/2")
2 Reverse side
* Before sewing, touch the automatic reinforcement stitching
key to sew reinforcement stitches automatically at the begin-
ning and at the end of the stitch.
2. Spread out the fabric along the finish line.
1 Finish line
2 Reverse side
3. Lay both seam allowances to the shorter one’s (cut one) side
and iron them.
1 Reverse side
4. Fold the longer seam allowance around the shorter one, and
sew the edge of the fold.
1 Reverse side
For reinforcing seams and neatly finishing edges
J
00