Nokia N73 - Manual (Page 91)

Tools
90
Line in use —This setting (network service) is shown only
if the SIM card supports two subscriber numbers, that is,
two phone lines. Select which phone line you want to use
for making calls and sending text messages. Calls on both
lines can be answered irrespective of the selected line.
If you select
Line 2 and have not subscribed to this network
service, you will not be able to make calls. When line 2
is selected,
is shown in the standby mode.
Tip! To switch between the phone lines, press
and hold
in the standby mode.
Line change —To prevent line selection (network service),
select Disable if supported by your SIM card. To change
this setting, you need the PIN2 code.
Connection
Data connections and access points
Your device supports packet data connections (network
service), such as GPRS in the GSM network. When you use
your device in GSM network, multiple data connections
can be active at the same time, and access points can share
a data connection.
To establish a data connection, an access point is required.
You can define different kinds of access points, such as:
• MMS access point to send and receive multimedia
messages
• Access point for the Web application to view WML
or XHTML pages
• Internet access point (IAP) to send and receive e-mail
and connect to the Internet
Check the type of access point you need with your service
provider for the service you want to access. For availability
and subscription to packet data connection services, contact
your network operator or service provider.
Access points
You may receive access point settings in a message from a
service provider. See "Data and settings," p. 52. Some or all
access points may be preset for your device by your service
provider or network operator, and you may not be able
to change, create, edit, or remove them.
indicates a
protected access point, and indicates a packet data
access point.
To create a new access point, select Options > New access
point . Select Use default settings to use the default access
point settings, or Use existing settings to select an existing
access point as the basis for the new access point.