Boss Audio Systems GT-6B - Manual (Page 70)

70
Chapter 10 Using MIDI
Enabling/Disabling the Program
Change Map Settings (MIDI Map Select)
This setting determines whether patches are switched
according to the Program Change Map settings, or to the
default settings when the GT-6B receives Program Change
messages.
1. Press [UTILITY], then press PARAMETER [ ]
[ ] so that “MIDI Map Select” is displayed.
fig.10-25
2. Rotate the PATCH/VALUE dial to select “Fix” or
“Prog.”
Fix: Switches to the patches according to the
default settings. For more on the default
settings, refer to “Initial Program Change Map
Settings” (p. 69).
Prog: Switches to the patches according to the
Program Change Map settings.
3. Press [EXIT] to return to the Play screen.
Changing Patch Numbers on an
External MIDI Device From the GT-6B
When patches are switched with the GT-6B, a Program
Change message is transmitted. The correspondence
between the GT-6B’s initial bank and patch numbers and the
transmitted Program Change messages is shown in the table
below.
Bank/Patch Number Program Number
U1-1 1
U1-2 2
U1-3 3
U1-4 4
U2-1 5
: :
: :
: :
U0-3 39
U0-4 40
u1-1 41
u1-2 42
: :
: :
: :
u0-3 79
u0-4 80
P1-1 81
P1-2 82
: :
: :
: :
P0-3 119
P0-4 120