Boss Audio Systems GT-6B - Manual (Page 65)

65
Chapter 10 Using MIDI
Chapter 10
Making the Settings for MIDI
Functions
Here is a description of the GT-6B’s MIDI functions. Set them
as needed, depending on the intended use.
1. Press [UTILITY] a number of times until the following
screen appears.
fig.10-03
2. Press PARAMETER [ ] [ ] so that the
parameter that you want to set appears in the display.
3. Rotate the PATCH/VALUE dial to change the setting
value.
4. Repeat steps 2–3 as necessary.
5. Press [EXIT] to return to the Play screen.
MIDI RX Channel (MIDI Receive Channel)
1–16
fig.10-03
This sets the MIDI channel used for receiving MIDI
messages.
* This was set to 1 when the unit was shipped from the factory.
MIDI Omni Mode
Omni Off, Omni On
fig.10-05
When set to “Omni On,” messages are received on all
channels, regardless of the MIDI channel settings.
* Even when Omni Mode is set to ON, the only Exclusive
messages received are those for Device ID data set with
“Device ID.”
* This was set to “Omni On” when the unit was shipped from
the factory.
MIDI TX Channel (MIDI Transmit Channel)
1–16, Rx
fig.10-06
This sets the MIDI Transmit channel used for transmitting
MIDI messages. When set to “Rx,” this MIDI channel is same
as the MIDI Receive channel.
* This was set to “Rx” when the unit was shipped from the
factory.
MIDI Device ID
1–32
fig.10-07
This sets the Device ID used for transmitting and receiving
Exclusive messages.
* This was set to 1 when the unit was shipped from the factory.
MIDI Sync Clock
Auto, Internal
fig.10-08
You can synchronize the performance of a sequencer or other
external MIDI device.
Auto: When no MIDI Clock from the external MIDI
device is being received, the performance is
synchronized to the tempo set in MASTER BPM;
when the external MIDI device’s MIDI Clock is
being received, the performance is synchronized
to that.
Internal: The performance is synchronized to the tempo set
in MASTER BPM.
* This was set to “Auto” when the unit was shipped from the
factory.
* When you have an external MIDI device connected, the
Master BPM is then synchronized to the external MIDI
device’s tempo, thus disabling the Master BPM setting. If you
want to be able to set the Master BPM, set to “Internal.”
* When synchronizing performances to the MIDI Clock signal
from an external MIDI device, timing problems in the
performance may occur due to errors in the MIDI Clock.