Boss Audio Systems GT-6B - Manual (Page 62)

62
Chapter 9 Other Functions
Setting “Expression Pedal Hold”
This setting determines whether or not the Pedal Assign’s (p.
45) operational status is carried over to the next patch when
patches are switched.
* Expression Pedal Hold does not function if the Assign Source
mode is set to Toggle (whereby the value is toggled between
Min and Max each time the pedal is pressed).
1. Press [UTILITY], then press PARAMETER [ ]
[ ] so that “EXP Pdl Hold” is displayed.
fig.09-06
2. Rotate the PATCH/VALUE dial to set Expression Pedal
Hold.
On: The Pedal Assign status is carried over.
(Example)
If a patch is switched while the volume is being
controlled with the expression pedal, the volume of the
subsequent patch will take on the value determined by
the current pedal position (angle).
If the expression pedal is controlling the wah effect in the
patch being switched to, then the volume assumes the
value set in the patch, and the patch’s wah effect is given
the value corresponding to the current pedal position
(angle).
Off: The Pedal Assign status is not carried over.
(Example)
If a patch is switched while the volume is being
controlled with an expression pedal, the volume of the
subsequent patch is set to the value set in that patch.
If the expression pedal is operated, and that information
is transmitted to the GT-6B, the volume changes in
accordance with the movement of the pedal.
3. Press [EXIT] to return to the Play screen.
Selecting the PATCH/VALUE
Dial Function (Dial Function)
This setting determines whether or not patches are switched
by rotating the PATCH/VALUE dial.
1. Press [UTILITY], then press PARAMETER [ ]
[ ] so that “Dial Func” is displayed.
fig.09-02
2. Rotate the PATCH/VALUE dial to select the PATCH/
VALUE dial function.
PATCH No.& VALUE:
The dial is used both for switching patches and changing
the value of settings. In addition to switching patches
with the pedals, you can also switch them by rotating the
PATCH/VALUE dial.When shipped from the factory,
you can use this setting.
VALUE Only:
In this setting, the PATCH VALUE Dial is used only for
changing the value of parameter settings, not patches.
3. Press [EXIT] to return to the Play screen.