Boss Audio Systems GT-6B - Manual (Page 54)

54
Chapter 7 Using Sound On Sound
You can use the “Sound On Sound function” by selecting
“SOS” with the REV/DLY Fx Select (p. 27).
Here, the Number 4 pedal and the BYPASS/CTL pedal
automatically function as Sound On Sound controls.
fig.07-01
Number 4 pedal: Stop, Erase
CTL pedal: Record, Play, Overdub
* The Number 4 pedal won’t function as the Sound On Sound
control pedal if the Patch Select mode (p. 60) has been set to
the Bank/Number method of selection.
The available recording time in “HiQlty” mode (in
which priority is placed on sound quality) is
approximately 3 seconds, and approximately 6 seconds
in “LongTime” mode (in which priority is placed on
longer recording time).
Procedure
fig.07-02
1. Confirm that the CTL pedal’s red
indicator is flashing.
This means that the GT-6B is in
recording standby mode and that
there is nothing in the memory.
Additionally, the rate at which the
indicator flashes indicates the
tempo, allowing you to use this as a quick tempo check
during recording.
* Depress the Number 4 pedal at least twice while “Tempo” (p.
29) is set to “BPM,” and the tempo is set to match the timing
you'’ve used while depressing the pedal (tap input).
fig.07-03
2. Press the CTL pedal to begin
recording.
The CTL pedal’s red indicator stops
flashing and stays lit, indicating that
the GT-6B is recording.
* Recording stops automatically as soon
as the amount that's been recorded
exceeds the available recording time.
3. Press the CTL pedal to end the recording.
When you stop recording, the recorded phrases
simultaneously starts playing back. The CTL pedal’s red
indicator light goes out, and the green indicator flashes,
indicating that playback is in progress.
In addition, the Number 4 pedal’s indicator lights up,
indicating that the memory contains recorded data.
fig.07-04
fig.07-05
4. Press the CTL pedal once again to
begin overdubbing.
Synchronize the overdub to the
recorded phrase.
The CTL pedal’s green indicator
flashes and the red indicator light
goes on, indicating that playback
and recording are being carried out simultaneously.
Each time the CTL pedal is pressed, playback and
overdubbing repeat.
5. When you have finished playback and overdubbing,
press the Number 4 pedal.
fig.07-06
6. If you want to erase the results of
your recording, press and hold
down the Number 4 pedal for at
least two seconds.
* The recorded content is temporary. Note that carrying out the
following procedures erases the recording.
• Turning off the power to the GT-6B.
• Switching to another patch
• Setting the REV/DLY Fx Select to anything other than
“SOS.”
• Switch for SOSMode
* For more information about each of the “SOS” parameters,
refer to p. 29.
Blink
Lit
Dark Blink Lit
Lit Blink
Dark