Boss Audio Systems GT-6B - Manual (Page 53)

53
Chapter 6 Using the Customize Function
Chapter
6
Making “Custom” Pedal
Wah Settings
Here, you can make three different sets of settings, Custom 1,
Custom 2, and Custom 3.
* Editing the Custom 1, 2, or 3 settings alters all tones in
patches that use these custom settings.
1. Press [WAH].
The WAH edit screen appears.
2. Press PARAMETER [ ] [ ] so that “FX Select” is
displayed, then rotate the PATCH/VALUE dial to select
“WH.”
3. Press PARAMETER [ ] [ ] until “Type”
appears in the display.
4. Rotate the PATCH/VALUE dial to select from “Custom
1–3.”
fig.06-03
5. Press PARAMETER [ ] [ ] to show the custom
parameters.
fig.06-04
6. Rotate the PATCH/VALUE dial to change the setting
value.
7. Repeat Steps 4 through 6 as needed.
8. Press [EXIT] to return to the Play screen.
Type
Selects the basic type of wah.
CRY WAH:
This models the ‘70s-type sound of the CRY BABY wah
pedal.
VO WAH:
This models the sound of the VOX V846.
Bass WAH:
Wah featuring a broader range of variations for the bass
range.
Q -50–+50
Adjusts the amount of characteristic effect applied to the wah
tone.
Range Low -50–+50
Selects the tone produced when the pedal is rocked back.
Range High -50–+50
Selects the tone produced when the pedal is pressed fully
forward.
Presence -50–+50
Adjusts the tonal quality of the wah effect.
Custom
Type
Custom
Q
Custom
Range Low
Custom
Range High
Custom
Presence