Boss Audio Systems GT-6B - Manual (Page 12)

12
Chapter 1 Playing Sounds
Making Connections
* To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices
before making any connections.
* Raise the amp volume only after turning on the power to all connected devices.
* When using mono output, connect the cable only to the OUTPUT L (MONO) jack.
* Use only specified expression pedals (optional Roland EV-5 or Roland FV-300L and PCS-33). Use of other manufacturer’s products may
result in damage to the unit.
fig.01-01
* To prevent the disruption of power to your unit (should the
plug be pulled out accidentally), and to avoid applying undue
stress to the AC adaptor jack, anchor the power cord using the
cord hook, as shown in the illustration.
fig.01-02
* The pin assignment for the OUTPUT (XLR) connector
connectors is as shown below. Before making any connections,
make sure that this pin assignment is compatible with that of
all your other devices.
fig.01-50
* When using the unit with an expression pedal connected to the
SUB EXP PEDAL/SUB CTL 1,2 jack, set Minimum Volume
of an expression pedal to the “MIN” position.
AC Adaptor
BRC-series
EV-5
FV-300L
etc.
FS-5U
FS-5L
etc.
Mixer
Stereo
Headphones
Bass Amp
Bass Guitar
1: GND
2: HOT
3: COLD
For more on how to use the OUTPUT (XLR) connectors,
refer to p. 55