Pioneer X-SMC5-K - Manual (Page 49)

Additional information 15
49
En
English
Français
Español
Wireless LAN
Cannot listen to Internet
radio stations. The firewall settings for components
on the network are currently in
operation. Check the firewall settings for components on the network.
You are currently disconnected from
the Internet. Check the connection settings for components on the network, and
consult with your network service provider if necessary (page 8).
The broadcasts from an Internet
radio station are stopped or
interrupted. Some Internet radio stations on the list of Internet radio stations for
this unit (page 53) may occasionally not be available for listening.
Problem Check Remedy
Problem Check Remedy
Network cannot be accessed
via wireless LAN. Is Network Type set to Auto and
the LAN cable connected to the unit? Switch Network Type to Wireless or disconnect the LAN cable
from the unit, then restart the unit.
If Network Type is set to Auto and the LAN cable is connected to
the unit, the unit recognizes the Network Type as Wired.
This unit and base unit (wireless LAN
router, etc.) are too far apart or there
is an obstacle between them. Improve the wireless LAN environment by moving the unit and base
unit closer together, etc.
There is a microwave oven or other
device generating electromagnetic
waves near the wireless LAN
environment. Use the system in a place away from microwave ovens or others
device generating electromagnetic waves.
Avoid using devices generating electromagnetic waves as much as
possible when using the system with the wireless LAN.
Multiple wireless devices are
connected to the wireless LAN
router. When connecting multiple wireless devices, their IP addresses
must be changed.
Wireless LAN connections cannot be
established between the unit and
base unit (wireless LAN router, etc.). The unit must be set in order to establish wireless LAN
connections. See Connecting using wireless LAN on page 9.
The IP address settings of the unit
does not match the settings of the
wireless LAN router, etc. Check the IP address settings of the unit (including the DHCP
setting).
If the unit’s DHCP setting is on, turn the unit’s power off, then turn
the power back on.
Check that the IP address of the unit matches the settings of the
wireless LAN router, etc.
If the unit’s DHCP setting is off, set an IP address matching the
network of the base unit (wireless LAN router, etc.).
For example, if the wireless LAN router’s IP address is
“192.168.1.1”, set the unit’s IP address to “192.168.1.XXX” (*1), the
subnet mask to “255.255.255.0”, the gateway and DNS to
“192.168.1.1”.
(*1) Set the “XXX” in “192.168.1.XXX” to a number between 2 and
248 that is not assigned to other devices.
The access point is set to conceal the
SSID. In this case, the SSID may not be displayed on the access point list
screen. If not, set the SSID, etc., by making the wireless LAN
settings on the unit manually.
The access point’s security settings
use WEP 152-bit length code key or
shared key authentication. The unit does not support WEP 152-bit length code key or shared
key authentication.
X-SMC5_SYXZT8_En.book 49 ページ ２０１１年７月２８日 木曜日 午後３時２７分