Troubleshooting, Additional information, Additional information 15 – Pioneer X-SMC5-K User Manual
Page 44: Chapter 15
Additional information
15
44
En
Chapter 15:
Additional information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this
component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components
and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your
nearest Pioneer authorized service center or your dealer to carry out repair work.
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug from the
outlet and insert again to return to normal operating conditions.
General problem
Problem
Check
Remedy
Settings you have made have
been cleared.
Was the power cord unplugged
forcibly while this unit’s power was
on?
Be sure to press STANDBY/ON on this unit’s top panel or press
STANDBY/ON on the remote control and wait for the POWER ON
indicator on the front panel display to turn off before unplugging
the power cord.
Power can’t be turned ON.
Is the Quick Start Mode set to On?
If the power cord is disconnected while Quick Start Mode is set to
On, the next time the plug is reconnected, about one minute warm-
up will be required before the unit responds. Wait for one minute
after reconnecting the cord before pressing STANDBY/ON.
Difference in volume
between DVDs, CDs, MP3,
WMA, iPod/iPhone and
Tuner.
This is not a problem with this unit.
The volume may sound differently depending on the input source
and recording format.
This unit cannot be operated
with the remote control.
Are you operating from far away?
Operate from within a distance of Operate within 7 m, 30° of the
remote sensor on the front panel (page 6).
Is the remote control sensor exposed
to direct sunlight or strong artificial
light from a fluorescent bulb, etc.?
The remote control signals may not be received properly if the
remote control sensor is exposed to direct sunlight or strong
artificial light from a fluorescent bulb, etc.
Are the batteries dead?
Replace the batteries (page 6).
The unit automatically turns
off or the demonstration
screen automatically starts.
Is Auto mode select set to Power
Save mode or Demo Mode?
Change the setting of Auto mode select to Off (page 32).
X-SMC5_SYXZT8_En.book 44 ページ ２０１１年７月２８日 木曜日 午後３時２７分