Configure nat, Onfigure – ADC MM701G User Manual
Page 86
Configure NAT
78
MM701G and MM702G User Manual
C
ONFIGURE
NAT
NAT provides the ability to map private IP address on the LAN to
public IP addresses (WAN) that are assigned to each session.
This essentially hides the private IP addresses behind the public
IP addresses assigned to WAN sessions. Prior to binding NAT to a
WAN IP address, you should have previously set up PPPoA routed, PPPoE routed, or RFC 1483
routed WAN sessions (see
“Configure a New WAN Session” on page 26
). You cannot
configure NAT for RFC 1483 bridged sessions.
1
Select
System
on the menu bar, then select
SmartCNCTSecurity
under
[Configuration]
to access
the
Security Interface Configuration
page.
SmartCNCTSecurity
System
This manual is related to the following products: