Access through the console port – ADC MM701G User Manual
Page 109
Appendix A: Accessing the Command-Line Interface
MM701G and MM702G User Manual
101
Access through the Console Port
Access the terminal emulation program (HyperTerminal, for example) to establish a connection
to the modem command-line interface. The following procedure uses HyperTerminal as the
example terminal emulation program. If you are using another terminal emulation program,
refer to the user documentation for instructions.
1
From the
Start
button, select
Programs
,
Accessories
,
HyperTerminal
.
2
In the HyperTerminal dialog, select
File
,
New
Connection
.
3
Enter a name for this connection and click
OK
.
4
For
Connect
using
, select the COM port (typically COM1) on the PC to which you have
connected the modem (console port connection), then click
OK
. The
COM1
Properties
dialog
is displayed.
5
In the
COM1
Properties
dialog, enter the
Port
Settings
as follows:
•
9600 baud
•
8 data bits
•
no parity
•
1 stop bit
•
flow control off (none)
6
Click
OK
.