Connect to the console port, Access the commandline interface, Access the command-line interface – ADC MM701G User Manual
Page 108: Onnect, Onsole, Ccess, Ommand, Nterface
Connect to the Console Port
100
MM701G and MM702G User Manual
C
ONNECT
TO
THE
C
ONSOLE
P
ORT
1
Install the flat gray console cable between the modem Console port and your PC as shown
below, using the DB-9 port adapter on the PC, if required.
A
CCESS
THE
C
OMMAND
-L
INE
I
NTERFACE
You can access the command-line interface through the direct connection to the modem console
port and using a terminal emulation program. You can also access the command-line interface
using a telnet session. To use a telnet session, you must have IP access to the modem either
through the 10Base-T LAN port (LAN-side access) or through an IP address assigned to a WAN
session (WAN-side access). The following sections provide instructions for setting up both
types of command-line interface access.
DSL LIN
E
PO
W
ER
MD
I
MDI-X
10B
AS
E-T
CO
NS
OL
E
Console port
Grey cable
PC
9-pin COM
port
Adapter
M0326-A