Add a new session – ADC MM701G User Manual
Page 115
Appendix A: Accessing the Command-Line Interface
MM701G and MM702G User Manual
107
Add a New Session
1
On the
WAN Session Management
menu, enter
2
to add a new session. The
Create new session
menu is displayed.
.
2
Select one of the following protocols for this session:
•
1—Create RFC
1483
bridged
session
if the modem forwards packets based on MAC
addresses. You can enable Spanning Tree when you select Bridge sessions. See
“Change Spanning Tree Setting” on page 51
.
•
2—Create RFC 1483 routed session
if the modem routes packets based on IP addresses.
•
3—Create PPPoA routed session
if the modem establishes PPP sessions over ATM with
the service provider and routes packets based on IP addresses.
•
4—Create PPPoE routed session
if modem establishes PPP sessions over Ethernet with
the service provider and routes packets based on IP addresses.