Client). see – ADC MM701G User Manual

Page 27

Chapter 3: Configuring the LAN

MM701G and MM702G User Manual

Select one of the following three DHCP server modes as indicated by your LAN
administrator, then click

Configure

•

Disabled

—

DHCP server mode

is not enabled. If you do not enable DHCP server for the

modem, you must enter a default gateway for each client on your LAN (such as PCs)
and also an IP address for a DNS server. Either the service provider or your LAN
administrator will provide you these IP addresses to enter in the Internet Protocol
(TCP/IP) setup for your PC (or other LAN clients). See

“Assign IP Addresses” on

page 7

for information about how to access this dialog. The following is an example

of the dialog and fields that must be filled in (example is from Windows 2000; the
dialog for other operating systems may be slightly different).

DHCP default gateway
IP address

DNS server IP address

Set Internet protocol to: Use
the following IP address:

This manual is related to the following products:

MM702G