Xerox WorkCentre M45-4033 - Manual (Page 53)

Page 4-4 Quick Reference Guide
Output
Output is used to select the finishing requirements for the job. The options will
depend on the finishing output device available.
Options:
Collated Select Collated for output stacked in sets to match the sequence of the originals.
Uncollated Select Uncollated for output sorted into stacks of individual pages.
Stapled Available if your machine is equipped with a finisher. It offers a selection of stapling
options. Collated and uncollated stapled sets will be delivered offset in the Finisher.
L Staples 2 - 50 sheets of 20lb, substance 20 paper. The maximum number of
sheets is 20 when stapling heavyweight paper.
Off-line
Stapling
For manual stapling, press and release the button on the top of the Finisher. The
green light will illuminate, if the light is flashing the stapler is unavailable. The Output
Tray lowers to provide access to the stapler and bin 1. Hold your documents and
place them into bin 1, for extra support move the rear bin 1 guide to the edge of your
documents. Slide the documents forward until you hear the click of the staple being
inserted to the front corner of the documents.
L Staples 2 - 40 sheets of 20lb, substance 20 paper. The maximum number of
sheets is 20 when stapling heavyweight paper.
Hole Punched If your machine is equipped with a Finisher, your machine will be set to either 2 or
3 Hole Punch. Each sheet is punched individually, so there is no limit to the number
of sheets in the set. Additional Hole Punch kits can be purchased as an option.
NOTE: Stapled and Hole Punched can be used together.