Xerox WorkCentre M45-4033 - Manual (Page 183)

Page 11-8 Quick Reference Guide
Output Quality
Stray marks or black marks from hole punched
originals are not removed
¾ Use the Edge Erase to erase the edge with the drilled holes.
¾ Copy from the document glass with the Document Cover down.
Images are out of sequence or upside down when the
Booklet Creation Feature is used
¾ Ensure that the originals are in the correct sequence.
¾ Feed LEF originals to SEF orientated paper stock.
¾ Enable the display options for Booklet Creation and ensure that the correct
sequence is selected (i.e.Left to Right or Right to Left).
The output is blank
¾ Ensure the originals are loaded either face up in the Document Handler or face
down on the Document Glass in the top right position.
Streaks, lines, spots, or black, solid, or dotted lines on
the prints
¾ Clean the Document Glass and if using the Document Handler the Constant
Velocity Transport Glass, especially near the plastic ramp on the glass.
¾ Clean the white underside of the Document Handler/Document Cover.
¾ Clean the Document Handler roller.
¾ Clean the halo guide.
¾ Run the job from the Document Glass.
¾ Check the quality of the original. Use Border Erase or Edge Erase to remove
lines from the edges of the document.
¾ Turn on Background Suppression.
¾ Load fresh paper.
¾ Do not use heavily embossed paper.