Xerox WorkCentre 7655-7665-7675-5897 - Manual (Page 33)

Configuring Printer Drivers 2-21
5 Enter the Device Name or TCP/IP address.
6 Select On to enable Bi-Directional communication.
7 Click OK. Bi-Directional communication is enabled. A Status button appears on the Paper/Output
tab of the printer driver. By clicking Status, you can access current information about the printer. See
About Bi-Directional Printer Drivers on page 2-23.
Configuring Installable Options—Manually
If your network environment does not support Bi-Directional communication, you can configure
installable options manually. See Bi-Directional Driver Support on page 2-24 to see if your network
environment is supported.
To configure the Installable Options manually:
1 At the desktop, click Start > Settings > Printers.
2 Right-click the appropriate printer icon and select Properties.
3 Select the System Configuration (Configuration) tab.
N OTE : To change the SNMP Community Name, click SNMP Community Name. The printer
name must be changed to match this name for Bi-Directional communication to be available.
Figure 2-7: System Configuration Tab (Properties Dialog)