Konica Minolta bizhub 25 - Manual (Page 110)

Specifying the Network Settings 2-57
1
2
Management
Item Description
Attribute Setting
Name 1 Set the name attribute. Up to 49 characters can be entered, and
the default value is “cn”.
Name 2 Set the name attribute. Up to 49 characters can be entered, and
the default value is “commonname”.
e-mail Address 1 Set the e-mail address attribute. Up to 49 characters can be
entered, and the default value is “mail”.
e-mail Address 2 Set the e-mail address attribute. Up to 49 characters can be
entered.
Fax Number 1 Set the fax number attribute. Up to 49 characters can be
entered, and the default value is “facsimileTelephoneNumber”.
Fax Number 2 Set the fax number attribute. Up to 49 characters can be
entered.
Telphone Number 1 Set the phone number attribute. Up to 49 characters can be
entered, and the default value is “telephoneNumber”.
Telphone Number 2 Set the phone number attribute. Up to 49 characters can be
entered.
Company Name 1 Set the company name attribute. Up to 49 characters can be
entered, and the default value is “company”.
Company Name 2 Set the company name attribute. Up to 49 characters can be
entered, and the default value is “o”.
Note
You can also specify LDAP settings using Message Board. For details, refer to Chapter
3, “Setting the Connection Environment” in the Message Board Guide.
Registering / Editing LDAP Servers „
This section describes the procedure for registering an LDAP server. When editing, select
the LDAP server you want to edit in step 6, and press [Edit]. After the screen in step 7 is
displayed, select the item to change.
Note
Up to five LDAP servers can be registered in the machine, but destinations cannot be
searched for on all the servers at the same time. Only one server can be searched at a
time.
Press .
1
Press [Management].
2
If an administrator password is set, enter the password and press [Enter].
3
If an administrator password is not set, proceed to step 4.
Press [Network Settings].
4