Konica Minolta bizhub 25 - Manual (Page 109)

2-56 Specifying the Network Settings
Registering LDAP Servers
You can search for destination information such as the e-mail address and name from an
LDAP (Lightweight Directory Access Protocol) server.
You can register the following information.
Item Description
Name This is the button name displayed on the screen. Up to 23
characters can be entered.
If nothing is registered, the first 23 characters of the LDAP
server address is displayed instead.
LDAP Server Address Enter the name or IP address of the LDAP server to register. Up
to 99 characters can be entered.
Port Number Enter the port number of the LDAP server.
A number between 0 and 65535 can be set, and the default value
is 389.
LDAP Server Login Set whether a login is required to access the LDAP server. Set
MB User Login, Account ID, and Password when you set this
setting to ON.
MB User Login Set whether to use the Message Board user information when a
login is required to access the LDAP server.
When this setting is enabled, if you register the LDAP server
authentication account and password in the user registration
of Message Board, it is not necessary to enter an account and
password each time a search is performed.
Account ID Register this when not using the Message Board user
information when a login is required to access the LDAP server.
If you do not register an account, the account will have to be
entered when a search is performed. Up to 49 characters can be
entered.
Password Register this when not using the Message Board user
information when a login is required to access the LDAP server.
If you do not register a password, the password will have to be
entered when a search is performed. Up to 29 characters can be
entered.
Search Base Enter the starting search position of the LDAP server. Up to 99
characters can be entered.
MaxNumber of results Set how many search results to display. An error is displayed
when the number of search results exceeds the maximum. A
number between 1 and 100 can be set, and the default value is
50.
Time Limit Set the maximum amount of time until the search results
are displayed. An error is displayed when the time taken for
search results exceeds the maximum. A number between 0 and
9999 seconds can be set for the time, and the default value is 0
(unlimited).
Optional Setting You can add search conditions to the parameters.
Additional Attribute Enter the search condition attribute to add. Up to 49 characters
can be entered.
Additional String Enter the search condition value to add. Up to 99 characters can
be entered.
Search Method Select the search method.