Cirrus Logic CS8415A - Manual (Page 9)

DS470F4 9
CS8415A
SWITCHING CHARACTERISTICS - CONTROL PORT - SPI MODE
Inputs: Logic 0 = 0 V, Logic 1 = VL+; C
L
= 20 pF.
12. If Fs is lower than 46.875 kHz, the maximum CCLK frequency should be less than 128 Fs. This is dic-
tated by the timing requirements necessary to access the Channel Status and User Bit buffer memory.
Access to the control register file can be carried out at the full 6 MHz rate. The minimum allowable input
sample rate is 8 kHz, so choosing CCLK to be less than or equal to 1.024 MHz should be safe for all
possible conditions.
13. Data must be held for sufficient time to bridge the transition time of CCLK.
14. For f
sck
<1 MHz.
Parameter Symbol Min Typ Max Units
CCLK Clock Frequency (Note 12) f
sck
0 - 6.0 MHz
CS High Time Between Transmissions t
csh
1.0 - -
µs
CS Falling to CCLK Edge t
css
20 - - ns
CCLK Low Time t
scl
66 - - ns
CCLK High Time t
sch
66 - - ns
CDIN to CCLK Rising Setup Time t
dsu
40 - - ns
CCLK Rising to DATA Hold Time (Note 13) t
dh
15 - - ns
CCLK Falling to CDOUT Stable t
pd
- - 50 ns
Rise Time of CDOUT t
r1
- - 25 ns
Fall Time of CDOUT t
f1
- - 25 ns
Rise Time of CCLK and CDIN (Note 14) t
r2
- - 100 ns
Fall Time of CCLK and CDIN (Note 14) t
f2
- - 100 ns
t r2 t f2
t dsu
t dh
t sch t scl
CS
CCLK
CDIN
t css
t pd
CDOUT
t csh
Figure 3. SPI Mode Timing