Winland Electronics EA400 - Manual (Page 40)

38 D-011-0093
Offset Adjustment
If desired, offset allows the temperature or humidity reading for the selected Zone to be
offset by a value that correlates the reading displayed on the EA200 / EA400 with that of
existing equipment.
Note: Allow a minimum of 15 minutes for temperature being monitored to
stabilize before making offset adjustments.
Enter an offset as follows:
1. Press the OFFSET key. The icon appears.
2. The flashing digit indicates the Zone at which the offset is to be applied. Use the
INCREASE or DECREASE keys to select the desired Zone, and then press the
ENTER key.
3. The flashing digit now indicates the offset value. Use the INCREASE or
DECREASE keys to select the desired offset value (±9 units range), and then press
the ENTER key.
The measured value added with the offset value is now displayed. (For example, if a
baseline measurement was 77 °F and an offset of –5° F was applied, the EA200 /
EA400 would now display 72 °F.)
Winland_English.fm Page 38 Wednesday, July 5, 2006 1:33 PM