Winland Electronics EA400 - Manual (Page 22)

20 D-011-0093
• At bottom of EA200 / EA400, pull the rear mounting plate down and away
from the EA200 / EA400 main chassis. The retainer tabs on the main chassis
will disengage from the holes in the rear mounting plate.
• Completely remove the mounting plate from the EA200 / EA400 main
chassis by disengaging the mounting plate upper hinges from the mating
tabs on the EA200 / EA400 main chassis.
2. Mount the mounting plate as follows:
• Mounting to 2-gang enclosure:
Use four (4) machine screws to secure the mounting plate to the mating
holes in the 2-gang enclosure.
• Mounting to drywall surface:
Place the mounting plate in mounting position. Mark the four mounting hole
locations. Install drywall anchors and secure the mounting plate to anchors.
Note: Where mounted to wall, a wiring access hole should be prepared at this time.
All wiring must pass through the opening in the center of mounting plate.
Winland_English.fm Page 20 Wednesday, July 5, 2006 1:33 PM