Alcatel-Lucent 7750 SR OS User Manual
Page 45
IP Router Configuration
7750 SR OS Router Configuration Guide
Page 45
autonomous-system
Assigns an autonomous system (AS) number to the router.
confederation
Creates a confederation within an AS.
ecmp
Enables ECMP and configures the number of routes for path sharing.
ignore-icmp-
redirect
Drops or accepts ICMP redirects received on the management interface.
mc-maximum-routes
Specifies the maximum number of multicast routes that can be held within
a VPN routing/forwarding (VRF) context.
service-prefix
Creates an IP address range reserved for IES and certain VPLS services.
The purpose of reserving IP addresses using service-prefix is to provide a
mechanism to reserve one or more address ranges for services.
static-route
Creates static route entries for both the network and access routes.
triggered-policy
Triggers route policy re-evaluation.
Configure a network interface
config>router>interface
address
Assigns an IP address, subnet and broadcast address format to an IP
interface. Only one IP address is associated with an IP interface.
allow-directed-
broadcasts
Enables the forwarding of directed broadcasts out of the IP interface.
arp-timeout
Configures the minimum time in seconds that an address resolution
protocol (ARP) entry learned on the IP interface will be stored in the ARP
table.
bfd
Specifies the bi-directional forwarding detection (BFD) parameters for the
associated IP interface
cflowd
Enables the collection of traffic flow samples through a router for analysis.
local-proxy-arp
Enables local proxy ARP on the interface.
loopback
Configures the interface as a loopback interface.
mac
Assigns a specific MAC address to an IP interface.
ntp-broadcast
Enables receiving of SNTP broadcasts on the IP interface.
port
Creates an association with an IP interface and a physical port.
proxy-arp-policy
Specifies an existing policy-statement to analyze match and action criteria
that controls the flow of routing information to and from a given protocol,
set of protocols, or a particular neighbor.
qos
Associates a network Quality of Service (QoS) policy with an IP interface.
remote-proxy-arp
Enables remote proxy ARP on the interface.
secondary
Assigns a secondary IP address, IP subnet/broadcast address format to the
interface.
Table 4: CLI Commands to Configure Basic IP Router Parameters (Continued)
Command
Description Page