Alcatel-Lucent 7750 SR OS - Manual (Page 306)

List of Commands
Page 306 7750 SR OS Router Configuration Guide
dot1p Configures an IEEE 802.1p value or range to be used as a MAC filter
match criterion. 383
etype Configures an Ethernet type II Ethertype value to be used as a MAC filter
match criterion. 385
dsap Configures an Ethernet 802.2 LLC DSAP value or range for a MAC filter
match criterion. 383
ssap Configures an Ethernet 802.2 LLC SSAP value or range for a MAC filter
match criterion. 387
snap-pid Configures an IEEE 802.3 LLC SNAP Ethernet Frame PID value to be
used as a MAC filter match criterion. 386
snap-oui Configures an IEEE 802.3 LLC SNAP Ethernet Frame OUI zero or non-
zero value to be used as a MAC filter match criterion. 385
Configure a redirect policy
config>filter
redirect-policy Enables the context to redirect policies. 359
description Creates a text description stored in the configuration file for a
configuration context. 357
destination Specifies a cache server destination (an IP address) to redirect packets
matching IP filter entry criteria. 390
ping-test The context to configure connectivity ping tests to validate the ability of
the destination to receive redirected traffic. 390
drop-count Specifies the number of consecutive ping test failures before declaring the
destination down. 390
interval The frequency at which the ping test, SNMP test, or URL test is executed. 391
timeout Specifies the amount of time in seconds that is allowed for receiving a
response from the far-end host. 391
priority The destination’s priority describes its relative importance within the
policy. If more than one destination is specified, the destination with the
highest priority value is selected. 391
snmp-test The context to configure SNMP test parameters. 392
oid The OID of the object to be fetched from the destination. 392
return-value Specifies the criterion to adjust the priority based on the test result. 392
url-test The context to enable URL test parameters. 393
url Specifies the URL to be probed by the URL test. 394
Table 18: CLI Commands to Configure Filter Policies Parameters (Continued)
Command Description Page