Alcatel-Lucent 7750 SR OS - Manual (Page 44)

List of Commands
Page 44 7750 SR OS Router Configuration Guide
List of Commands
Table 4 lists all the configuration commands to configure a 7750 SR-Series router, indicating the
configuration level at which each command is implemented with a short command description.
Refer to each specific chapter for specific routing protocol information and command syntax to
configure protocols such as OSPF and BGP.
The command list is organized in the following task-oriented manner:
• Configure the system name
• Configure the router ID
• Configure router parameters
• Configure a network interface
• Configure the system interface
• Configure IPv6 parameters on an interface
• Configure router advertisement parameters
• Configure interface ICMP
Table 4: CLI Commands to Configure Basic IP Router Parameters
Command Description Page
Configure the system name
config>system 49
name The system name for the device. Only one system name can be configured.
Configure the router ID
config>router 72
router-id Configures the router ID for the router instance. When configuring a new
router ID, protocols will not automatically be restarted with the ID. The
next time a protocol is initialized, the new router ID is used. This may lead
to an interim period of time where different protocols use different router
IDs 89
Configure router parameters
config>router 49
aggregate Creates an aggregate route. Aggregate routes group a number of routes
with common prefixes into a single entry in the routing table, thereby
reducing the number of routes that need to be advertised by this router and
the routing tables of downstream routers. 86