Alcatel-Lucent 7750 SR OS - Manual (Page 153)

IP Router Configuration
7750 SR OS Router Configuration Guide Page 153
next-hop ip-address — Only displays static routes with the specified next hop IP address.
Values ipv4-address: a.b.c.d (host bits must be 0)
ipv6-address: x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x:
[0 — FFFF]H
d: [0 — 255]D
tag tag — Displays the tag used to add a 32-bit integer tag to the static route. The tag is used in route
policies to control distribution of the route into other protocols.
Values 1 — 4294967295
Output Static Route Output — The following table describes the output fields for the static route table.
Sample Output
A:ALA-A# show router static-route
===============================================================================
Route Table
===============================================================================
IP Addr/mask Pref Metric Type Nexthop Interface Active
-------------------------------------------------------------------------------
192.168.250.0/24 5 1 ID 10.200.10.1 to-ser1 Y
Label Description
IP Addr/mask The static route destination address and mask.
Pref The route preference value for the static route.
Metric The route metric value for the static route.
Type BH — The static route is a black hole route. The Nexthop for this type of
route is black-hole .
ID — The static route is an indirect route, where the nexthop for this
type of route is the non-directly connected next hop.
NH — The route is a static route with a directly connected next hop. The
Nexthop for this type of route is either the next hop IP address or an
egress IP interface name.
Next Hop The next hop for the static route destination.
Protocol The protocol through which the route was learned.
Interface The egress IP interface name for the static route.
n/a — indicates there is no current egress interface because the static
route is inactive or a black hole route.
Active N — The static route is inactive; for example, the static route is disabled
or the next hop IP interface is down.
Y — The static route is active.
No. of Routes The number of routes displayed in the list.