Kramer Electronics VP-4x1CS - Manual (Page 37)

34 VP-4x1CS - Protocol 3000
12.2 Kramer Protocol 3000 Commands
Command
Short
Form
Description Permission
# Protocol handshaking End User
ADL Set audio level in specific amplifier stage
ADL? Read audio volume level
AUD-LVL ADL Set audio level in specific amplifier stage
AUD-LVL? ADL? Read audio volume level
AV Switch audio and video
BUILD-DATE? Read device build date End User
ETH-PORT ETHP Change protocol Ethernet port
ETH-PORT? ETHP? Read protocol Ethernet port
FACTORY Reset to factory default configuration
INFO-IO? Read in/out count End User
INFO-PRST? Read maximum preset count End User
LOCK-FP LCK Lock front panel Administrator
LOCK-FP? LCK? Read Lock front panel End User
MODEL? Read device model End User
NET-DHCP NTDH Set DHCP mode
NET-DHCP? NTDH? Read subnet mask
NET-GATE NTGT Set gateway address
NET-GATE? NTGT? Read subnet mask
NET-IP NTIP Set IP address
NET-IP? NTIP? Read IP address
NET-MAC? NTMC Read MAC address
NET-MASK NTMSK Set subnet mask
NET-MASK? NTMSK? Read subnet mask
P2000 Switch to Protocol 2000 End User
P3000 Switch to Protocol 3000 End User
PRIO Set switching priority End User
PRIO? Get switching priority End User
PROT-VER? Read device protocol version End User
RESET Reset device Administrator
SIGNAL? Get valid/invalid status End User
SN? Read device serial number End User
VERSION? Read device firmware version End User
VID Switch Video only End User
VID? Get Video switch state End User
VOL Set simple audio volume
VOL? Read simple audio level
VOLUM VOL Set simple audio volume
VOLUM? VOL? Read simple audio level