Kramer Electronics VP-4x1CS - Manual (Page 17)

14 VP-4x1CS - Operating the VP-4x1CS 4x1 PC Graphics Clean Switcher
7 Operating the VP-4x1CS 4x1 PC Graphics
Clean Switcher
The VP-4x1CS can be operated:

Locally using the front panel buttons (see Section 7.1 )

Remotely using:

The embedded Web pages (see Section
7.2
)
 The K-Single Application (see Section 7.3 )
7.1 Operating the VP-4x1CS Locally
This section describes:

Setting a priority Input (see Section 7.1.1 )

Switching Between Protocol 2000 and Protocol 3000 (see Section
7.1.2
)

Locking and unlocking the front panel buttons (see Section 7.1.3 )

Resetting the device to factory default settings (see Section 7.1.4 )

Upgrading the VP-4x1CS firmware (see Section 7.1.5 )

EDID Handling (see Section 7.1.6 )
7.1.1 Setting a Priority Input
When a priority input is set, the VP-4x1CS cycles through the inputs from 1 to 4
(beginning with the priority input) looking for a live signal. If there is no signal on
the priority input the device cycles through the inputs (from low to high) and
selects the first input that is encountered with a live signal.
Note: When a priority Input is selected, the device does not perform clean
switching.
Note: For clean switching, all extracted sources must be of the same resolution.