Bell & Gossett 10-001-278 XLS Integrated Pump Controller - Manual (Page 9)

9
a. By tapping , in either Idle or Auto Modes, an
enhanced screen shown in Figure 10 will appear to
set individual pump status.
Figure 10: Pump Switch Screen
2. Pump Status Detail:
Figure 1 1 : P u m p D e t a i l
a. By tapping , an enhanced screen shown in
Figure 12 will appear with more detailed
information.
Figure 12: P u m p I n f o r m a t i o n
STATION DISCHARGE STATUS
The station discharge status bar will display the current
discharge conditions for the station.
Figure 13: Station Discharge Status
MODES OF OPERATION
The HMI will display various modes of operation with
dedicated screens. These modes of operation can be
accessed through the interface on the home screen.
1.
IDLE MODE will be active when the unit is not in
[MANUAL] or [AUTO] and the pumps will not be
allowed run.
Figure 14: Basic Booster Idle Screen
2.
Auto Mode is activated /deactivated by tapping
[AUTO]. To enter or exit this mode of operation
simply tap [AUTO] from the IDLE screen.
*Details on setting up the station for proper AUTO
operation are detailed in the startup procedure.
3.
Manual Mode is activated/deactivated by tapping
[MANUAL] from the home screen. When activated,
a dedicated screen will appear as shown in Figure
15 to allow manual operation of individual pumps.
Figure 1 5 : Basic Booster Manual Screen
a. [ON], allows for the manual ability to turn on/off
the pump.
a
b
- Status
- Percent Speed
- Hertz
- kW
- Flow Rate
- Total runtime