[events, [email setup – Bell & Gossett 10-001-278 XLS Integrated Pump Controller User Manual

Page 15

Figure 34: Individual Lockout Setup

The screen shown in Figure 34 sets up a lockout
for Sunday beginning at 6:00 AM. The duration is
set to be 12 hours. Thus this lockout will end at
6:00 PM on Sunday. The animated display gives
an indication about time.

Figure 35: Parameter Tab in Lockout

Setup

The Parameter tab enables a user to define Combo
number, maximum pressure, and maximum speed
in RPM

2. [Events]

By tapping [Events] you will be taken to the Events
home screen shown in Figure 39. This page will
detail any event that has happened within the given
period.

Figure 36: Event Setup

By tapping [Period] you will be able to adjust the
range to show only information required.

Tapping [< Back] will take you back to the Service
Home Screen.

3. [Email Setup]

This page allows you to set up email addresses
where Alarm and shutdown messages will be
sent. These emails will notify the user if the
station has shut down or experienced a problem
that the site personnel should be aware of. This
way the user will be notified immediately in case
of a pump station problem. If a fault occurs, an
email will be sent to him.

The email settings can be configured to send
emails to multiple individuals or email addresses.
The vast majority of cell phone providers also
allow email messages to be sent to cell phones
as text messages. A list of known formats is
provided below.

Enable: Check this box to enable email
alarms from the Pace controls.

Use Authentication: Check this box if your
email service requires POP3 authentication.

Note: The POP3 and SMTP servers will usually
have the same address. Enter this value in both
boxes. Sometimes the values are different so
separate boxes have been provided.

To: Enter the email address where the alarm
messages will be sent to. Multiple email
addresses can be entered by separating the
email addresses with a semicolon.

Examples:

;

;

;