Bell & Gossett 10-001-278 XLS Integrated Pump Controller User Manual

Page 13

If an alarm is active the Home screen will also display
various visual warnings to alert the system status

Figure 25: Alarm Warning

a. The [ALARM] will turn red to alert that there is an

active alarm.

b. [Reset Alarm] will flash from yellow to red to indicate

there is an active alarm. By tapping [Reset Alarm],
the alarm will be acknowledged.

c. The pump status will show an alarm state

SETPOINTS

The [SETPOINTS] tab will take you to the Setpoint detail
screen. From this screen you will be able to view the
station setpoints along with the current values of certain
parameters.

Figure 2 6 : Setpoint Home Screen

a. This portion of the screen displays the current

running set point of the station and the “enable
writes” check box. By checking this box any
changes made while in this screen will be saved.

By leaving it unchecked no changes can be
made.

Figure 2 7 : Setpoint Detail A

b. This portion of the screen will display the current

set points being used by the system. When
tapping in the numbered area an enhanced
keypad will appear that will allow you to change
the current value.

Figure 2 8 : Setpoint Detail B

If factory configured, checking the “Use AI”
check box will allow control by a factory
configured Analog Input. This input is separate
from the settings for remote transducers or BMS
override. If you do not have an external AI
configured, these boxes should remain
unchecked.

The “Input” indicator will be active if that current
input is on.

c. “Lockout Setpoint” will display what the Lockout

system has identified as the required set point.

“Remote (Comm)” enable is the setpoint being
communicated by the remote communication
system. The enable box must be checked in
order for the remote communication system to
adjust the system set point.

Figure 2 9 : Setpoint Detail C

d. This portion of the screen will display the Remote

Transducer Settings. The remote transducers are
enabled in the System Setup - Control Options
section. If you have configured/enabled the
remote transducers the “Current” box will display
a value. If not it will show 0.0. By checking the
enable box the system will use the configured
remote transducers.