[set/sync hmi-plc date/time – Bell & Gossett 10-001-278 XLS Integrated Pump Controller User Manual

Page 16

The following list shows email address formats for
various cell carriers. Sending an email to these
addresses will generate an SMS text message to the
cellular phone

here “phonenumber” is the 10 digit

phone number of the user.

T-Mobile:

Virgin Mobile:

Cingular:

Sprint:

Verizon:

Nextel:

US Cellular:

SunCom:

Powertel:

AT&T:

Alltel:

Metro PCS:

SMTP: Enter the IP address of the SMTP
server you will be using. Windows CE devices
require the IP address rather than the server
name.

See “Determining the IP address of the
SMTP

server” in Appendix F for these

instructions.

From: Enter the complete email address
used for this service. Most email servers will
ignore your email request if the “From”
address does not match the account.

Example: [email protected]

User: For most email service providers, enter
the first part of the email address without the

domain name. Note that some providers
require the full email address as your user
name.

Example: mypumpstation

Password: The password to your email
account. Example: Xlem1234

After configuring your email settings, test the
setup.

Tap [Set] to load the information into the
email generator. Then tap [Send]. A test email
will be immediately sent to the address(es)
provided.

If the colored box remains green after hitting
Send, the configurations are working
correctly. If the box turns red there has been
an error. The number after “Status” indicates
the type of error, table for which can be found
in Appendix F.

Additional troubleshooting options for email
configuration can also be found in Appendix
F.

Figure 37: Email Settings

Occasionally, the settings changes here
may require restarting the HMI. Try this if
you experience problems getting the test
email to work. This can be accomplished
through cycling power or by shutting
down and restarting the application. Then
see appendix “F” for other
troubleshooting aids.

4. [Set/Sync HMI-PLC Date/Time]

Tap [Set/Sync HMI-PLC Date/Time] from the
SERVICE menu.