Bell & Gossett 10-001-278 XLS Integrated Pump Controller User Manual
Page 17
17
Figure 3 8 : Set/Sync Screen
This screen allows the date and time to be set,
and synchronized for the PLC and HMI. To
manuall y s et the date check “Change
Date/Ti me”. Note the Date and Ti me boxes
wil l changed to edi tabl e fi el ds. To allow for
Dayli ght Savings Ti me pl eas e check the
appropri ate box .
Tap [Set Date] to synchronize HMI & PLC date
and time. You will get a pop up message shown
below, hit [OK].
Figure 3 9 : Sync Pop-up Detail
To adjust the totalizers tap [Totalizers]. In the new
pop up you will be able to adjust the time/date
when the system will totalize.
Figure 4 0 : Clear/Update Totalizers
Use the available cells to enter the date and time.
Tap [Set Date/Time] to save changes. Tap [Clear
Totalizers] to clear all totalizers.
Note that when the HMI time is set, the HMI will
automatically sync the PLC time once/day.
Synchronization should not be done while using
the Internet-based remote client as this has the
potential to negatively affect the time settings of
the system. Syncing should only be performed
locally.
5. [Security Setup]
Tap [Security Setup] from the SERVICE Menu.
Figure 4 1 : Security Setup Home Screen
The Supervisor can change the password
assigned to him/her, and set the number of days
after which the password expires (in the editable
field). To change the password, tap [Change
Password] to change the supervisor password.
Enter the new password in the ‘Password’ and
‘Confirm Password’ field. Tap [Apply] to save
changes.