Bell & Gossett 10-001-278 XLS Integrated Pump Controller - Manual (Page 21)

21
Typical BacNet communications settings are as
follows:
Page BacNet - Link
Serial Encapsulation TCP/IP
Link Type BacNet IP
Device UDP Port 47808
MSTP MAC
Page
BacNet - Modem
Configuration
Modem Identifier Auto Detect 2
Phone Number Required>
Page BacNet - Modem Options
Enable incoming calls No
Auto Connect Enable Yes
Auto Connect Retry
Interval (s) 120
Disconnect if call idle
more than... 1
Auto-Disconnect time (s) 120
Page BacNet - Com Port
Com Port COM2
Baud 9600
Data Bits 8
Stop Bits 1
Parity None
Page BacNet - TCP and UDP
IP Address 192.168.1.15
Port # 47808
Server Mode Yes
Page BacNet - Advanced - A
Protocol-Station 1
Protocol-Retries 0
TX Buffer 512
RX Buffer 512
Page BacNet - Advanced - B
TimeOut-Start 1000
TimeOut-End 0
TimeOut-Interval Between
Char 500
TimeOut-Wait CTS 100
Page BacNet - Advanced - C
Control RTS No
Verify CTS No
Disable DTR No
Enable IR No
Table 2: BacNet Settings
Setup/Configuration File
ActiveX and IP Updates
Tap [ActiveX and IP Updates] from the Options
Setup Menu.
By default both ISSymbol URL and Agent URL are
automatically populated.
View Current Configuration: View the entire URL
in a popover screen.
Set Configuration: Set and save new web
configurations.
Email: Get notifications via email.
Tap [Close] to return to the Options Setup Menu.
Figure 51: ActiveX and IP Updates
WinCE Remote Access
Tap [WinCE Remote Access] from the Options
Setup Menu
This screen allows you to communicate with a remote
server using Telnet. This feature is intended for
advanced custom jobs.
CAUTION:
Before using this feature or changing any settings
on this screen, please call customer service.
Tap [Close] to return to the Options Setup Menu.