NOVUS TagTemp-USB - Manual (Page 5)

TagTemp-USB
NOVUS AUTOMATION 5/5
7 MOST FREQUENTLY FOUND PROBLEMS
The LED is not flashing: The LED flashing light is intentionally
weak, and it can be difficult to see it in clear environments, certify it is
really not flashing.
Communication with the equipment fails:
Make sure the COM port is selected correctly and there is no other
program using the same port during communication attempts;
Make sure there is no physical obstacle blocking the infrared signal;
Make sure the cable is well connected to the PC port;
Make sure the port selected does not present any problem.
8 SPECIAL CARE
When handling the device and its battery, observe the following:
• When the device is opened, avoid touching the electronic
components and the printed circuit board to avoid electrostatic
discharge damages.
• Pay close attention to battery polarity.
• When closing, the cover and its sealing must be mounted
correctly and carefully to ensure the enclosure sealing.
• Used batteries must be disposed in accordance to local
regulations. Don’t try to recharge, dismount or heat, since
explosion may occur.
9 WARRANTY
Warranty conditions are available on our web site
www.novusautomation.com .