American Electric Lighting IN-281 - Manual (Page 2)

ACP LED Flood Instruction Sheet
Full and Upper/Bottom Visor
IN-281
1 INTRODUCTION
1.1 Product Description
The Full Visor is intended to limit the light directed to the sides and
above/below the luminaire, and the Upper/Bottom Visor is intended to
limit the light directed above or below the luminaire. Each kit,
ACP1LED FV and ACP1LED UBV for the medium and ACP2LED FV
and ACP2LED UBV for the large, consists of a visor and (4) #8
screws.
2 INSTALLATION
2.1 Tools and Materials Required.
DESCRIPTION USE
1/4” Socket or Nut Driver Visor Screws
2.2 Full Visor Installation.
Install the provided screws through the visor mounting holes and into
the mounting holes on the door as shown in Figure 1.
Figure 1
GR2287
2.3 Upper/Bottom Visor Installation.
Orient the visor to the desired position, and then install the provided
screws through the visor mounting holes and into the mounting holes
on the door as shown in Figures 2 or 3.
Figure 2
GR2288
Figure 3
GR2289
©2014 Acuity Lighting Group, Inc.