Troubleshooting – COOK HMD EN User Manual
Page 13
13
Excessive noise or vibration
No
No
No
No
Is the belt loose or
damaged?
Clean or replace the wheel.
Align sheaves.
Lubricate or replace bearings as needed.
Clean or replace filters as needed.
Are the sheave aligned?
Is the wheel
unbalanced?
Are the filters dirty /
clogged?
Are the bearings worn or
do they need lubrication?
Yes
Yes
Yes
Yes
Yes
1. Replace or tighten as needed.
2. Install automatic belt tensioner if possible.
At this time the noise or vibration
should be at acceptable levels
Troubleshooting
No
Refer to the control panel parts list when troubleshooting.
See also other documents in the category COOK Kitchen:
- AC (12 pages)
- ACSC (8 pages)
- VA (12 pages)
- ASP (8 pages)
- Automatic Belt Tensioner Supplement I (2 pages)
- Automatic Belt Tensioner Supplement II (2 pages)
- CA (16 pages)
- CA-4 (1 page)
- CCP (8 pages)
- CFS (8 pages)
- CIC (12 pages)
- CPL (8 pages)
- CV (8 pages)
- Duct Blower (8 pages)
- EC Motor Wiring (1 page)
- Constant Pressure Control System (2 pages)
- Economizer Fan (8 pages)
- ERV (16 pages)
- ERV Evaporator Coil Supplement (2 pages)
- ERV Fluid Coil Supplement (2 pages)
- FCE (6 pages)
- FCP (8 pages)
- Gemini (8 pages)
- Gemini (1 page)
- GEMINI 100 SERIES PRE-2014 MOTOR (1 page)
- GEMINI 200, 300, & 500 PRE-2014 MOTOR (1 page)
- Gemini 100 Series (4 pages)
- Curtain Style Ceiling Radiation Damper (1 page)
- Gemini with Motion Sensor (2 pages)
- GI (4 pages)
- Hinged Base (2 pages)
- IMH (8 pages)
- Inlet Vane Damper (1 page)
- Laboratory Exhaust (17 pages)
- Laboratory Exhaust (4 pages)
- Laboratory Exhaust (18 pages)
- Power-Plume (4 pages)
- TCN (12 pages)
- QMX (12 pages)
- LC (8 pages)
- Lo-Pro (8 pages)
- Motor Pack (2 pages)
- Universal Motor Pack (2 pages)
- PR (2 pages)