COOK GEMINI 100 SERIES PRE-2014 MOTOR - Manual

GEMINI 100 SERIES WITH GRILLE REMOVED
INTERNAL ASSEMBLY
DATE:
GEMINI
GEMINI 100 SERIES
PRE-2014 MOTOR
REPLACEMENT
INSTRUCTIONS
PROJECT:
LOCATION:
-
-
-
GREEN GROUND WIRE TERMINAL MUST BE
FASTENED TO INTERNAL HOUSING SCREW
AS SHOWN.
INSTALLATION INSTRUCTIONS:
1. SHUT OFF AND LOCK OUT POWER TO FAN.
2. REMOVE GRILLE
3. UNPLUG MOTOR CABLE FROM FIELD WIRING BOX.
4. REMOVE (4) SCREWS HOLDING INTERNAL ASSEMBLY
TO HOUSING AND PREPARE TO DIS-ASSEMBLE.
5. USE A ALLEN WRENCH TO LOOSEN CLAMP AND REMOVE FAN WHEEL.
6. REMOVE (4) HEX NUTS TO REMOVE MOTOR.
7. INSTALL MOTOR IN REVERSE ORDER AND REPLACE
INTERNAL ASSEMBLY MAKING SURE TO FASTEN RING TERMINAL
OF GREEN WIRE TO ONE OF THE (4) MOUNTING SCREWS IN
ORDER TO PROPERLY GROUND THE MOTOR.
8. CONNECT PLUG FROM MOTOR TO PLUG IN FIELD WIRING BOX.
9. RESTORE POWER TO FAN AND INSPECT FOR PROPER OPERATION.
10. REPLACE GRILLE.
MOTOR
FAN WHEEL
HEX NUT
FLAT WASHER
RUBBER
ISOLATOR
WHEEL
CLAMP
INLET
PLATE
FIELD WIRING BOX