Sony SVR-3000 - Manual (Page 84)

77
Q u e s t i o n s a b o u t C h a n n e l s
I can’t get the channel to change (continued).
• Refer to the Start Here booklet to verify that the IR Control cable is positioned
correctly.
• Press the TiVo button to go to TiVo Central, then select Messages & Setup, then
Cable/Satellite Box, then Control Cable Setup. Verify the IR code you chose during
Guided Setup. See page 8 for help choosing an IR code.
• If the installation instructions required you to connect a serial control cable, check that
the Serial Control cable is plugged into the upper serial jack on the back of the
recorder.
• Unplug the cable box from the wall, then plug it back in.
If you use a satellite receiver with an IR Control cable:
• Make sure the satellite receiver is turned on.
• Refer to the Start Here booklet to verify that the IR Control cable is positioned
correctly.
• Press the TiVo button to go to TiVo Central, then select Messages & Setup, then
Cable/Satellite Box, then Control Cable Setup. Verify the IR code you chose during
Guided Setup. See page 8 for help choosing an IR code.
• Unplug the satellite box from the wall, then plug it back in.
If you use a satellite receiver with a serial control cable:
• You may have incorrectly specified the type of program guide for your DIRECTV
satellite receiver. There are two types of program guides: MPG (Master Program
Guide) and APG (Advanced Program Guide). First, unplug the power cord for the