HID EDGE EVO EH400 Hi-O Controller Installation Guide - Manual (Page 10)

EDGE EVO Hi-O Networked Controller
EH400
82000-920 C.0
INSTALLATION GUIDE 10 ©2009 - 2011 HID Global Corporation. All rights reserved.
Hi-O Interface Modules
Hi-O interface modules are used to interface the EDGE EVO device (Controller / Reader & Module or Network Controller) with
door electronic components. Components include access control readers, strike, magnetic lock, request to exit, door position
switch, and auxillary devices.
For Hi-O interface module wiring, see their respective Installation Guides.
Go to
www.hidglobal.com > Support > Document Library.
Search the document type as a Installation Guide.
Model Description Part Number
EDM-M EDGE EVO Door Module 82342
EIM-M EDGE EVO Input Module 82340
EWM-M EDGE EVO Reader Module 82360
EDWM-M EDGE EVO Door & Reader Module 82363AM
ELM EDGE EVO Lock Module 82301
EVM EDGE EVO Voltage Module 82365
Glossary
Acronym Description Acronym Description
AC Fail AC Power Failure Input Sense GND Ground
AUX Auxillary Input or Output GRN LED Green LED Output
BATT Fail Battery Failure Input Sense GRP SEL Group Select
CAN_H Hi-O CANbus High NC Normally Closed
CAN_L Hi-O CANbus Low NO Normally Open
CLK Clock PIR Passive Infared device
COM Common PoE Power over Ethernet
Data0 Wiegand Data 0 Input RED LED Red LED Output
Data1 Wiegand Data 1 Input REX Request-to-Exit Input
Door Mon Door Monitor Input RLY Relay
DS Door Strike