Swiftech H20KITS - Manual (Page 8)

1703 E. 28 th St., Signal Hill, CA 90755
Tel (562) 595-8009 - Fax (562) 595-8769
URL: HTTP://WWW.SWIFTNETS.COM
8
1. Open valve 2 for a couple of seconds,
allow any air trapped into the valve to
escape. Close valve 2 again.
2. Now, close valves 3 and 1, and open
valve 2. The system is now full, bled,
and ready to use, as shown in the
picture to the right.
3. Turn off the pump by disconnecting it
from A/C.
4. With both tubes still inside valves 1
and 3, carefully place the holding
tank below the computer (on the floor
for example)
5. Disconnect the tubes from valves 1
and 3. Whatever little liquid was still
trapped in the tubes will flow back
into the holding tank without making
a mess :-)
6. FINALLY, REMEMBER to reconnect
the L wire from the socket to the N\O
position on the switch !
- Intentionally left blank -