Swiftech H20KITS User Manual
Installation guide
1703 E. 28
th
St., Signal Hill, CA 90755
Tel (562) 595-8009 - Fax (562) 595-8769
URL: HTTP://WWW.SWIFTNETS.COM
1
C
C
O
O
M
M
P
P
U
U
T
T
E
E
R
R
L
L
I
I
Q
Q
U
U
I
I
D
D
C
C
O
O
O
O
L
L
I
I
N
N
G
G
K
K
I
I
T
T
INSTALLATION GUIDE
Check-marked for applicable model and content
Intel P3 Socket 370, AMD Athlon/Duron socket 462
AMD Athlon/Duron socket 462, Intel P4 socket 423, 478, 603/604
This kit includes (Check-marked for applicable model and content) :
Qty Item
1
Radiator model RAD 676, gasket, mounting screws, 5’ of 3/8” OD tubing
!
2
120mm fans, 55 CFM
1
Fill & bleed kit, 2’ of ¼” tubing
!
1
MCP300
Inline Pump with 3/8” reducer quick-connect adapters, and Velcro harness
!
1
Pump switching relay kit, including A/C socket, Switch CB, mounting plate, mounting screws, A/C cord
Water block model ->
None
MCW372
MCW462-U
MCW462-UT
Preamble
This kit is meant for advanced users, and designed for heavy thermal loads such as, but not limited to:
•
Extreme overclocking, Dual processors, Thermoelectric cooling, High ambient temperatures
Due to considerable variations in case sizes and designs, Swiftech cannot guarantee that some of the
peripherals, in particular the radiator, will fit inside your case.
Tools needed to complete the installation:
•
Power drill
•
4/6 Bi-Metal Hole Saws
Milwaukee 49-56-0230
4-1/2" (115 mm) to open up two holes for
the 120mm fans
•
1 ¼” (32mm) Bi-Metal hole saw for Pump
switch mounting
•
.5" drill bit (12.7mm) to route the two tubes
inside the case (protected by two
grommets, included in kit)
•
3/16 (4.75mm) Drill bit for fan mounting
holes
•
1/8” (3.17mm) Drill bit for radiator
mounting holes