Swiftech H20 120 PREMIUM User Manual

Page 9

http://www.swiftnets.com

Rouchon Industries, Inc., dba Swiftech – 1703 E. 28

Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail: [email protected]

PAGE 9 of 26

B. Housing/Fan/Radiator installation

Once you have found a satisfactory position for the Radbox base plate, secure the housing and fan to the radiator using the provided (4) M3.5
x 30mm Philips screws. Ensure that the exit of the fan wire is positioned towards the bottom of the PC and to its left (towards the motherboard)
to facilitate further routing of the wire through the PCI pass-thru.

C. Finalizing the installation
Secure the housing/fan/radiator assembly to the base plate with the provided #4 screws. With the radiator in its final place, you can now cut
two pieces of tubing of sufficient length to connect inlet and outlet of the radiator to the PCI pass-thru nipples. The tubes will form some sharp
bends here, and you must wrap them with the provided Smartcoils by forming tight loops in order to prevent the tubes from kinking. Please
refer to the Smartcoils installation in the chapter 4 for further details on how to use Smartcoils. Once done slip the tubes over their respective
fittings, and secure them with the provided hose clamps.

D. Electrical connection
The fan shipped with the MCR120 uses a 3-pin connector. For 12volt operations, this connector can be safely installed on one of the
motherboard headers. Use any free header other than the CPU fan header, since the pump RPM sensor will be connected to the CPU fan
header in order to monitor the pump.

For low noise operations, 2 additional fan connector adapters are supplied with the kit, and should be connected to the power supply instead
of a motherboard fan header:

12v to 7v adapter: this setting provides a good balance for performance, at whisper quiet operations
12v to 5v adapter: this setting is for silent operations, and will result in higher processor temperatures.
Please consult the product page (

www.swiftnets.com/products/h20-120-premiunm.asp

) on our web site for specific data

with respect to CPU temperatures when using the 12 to 7V or 12 to 5V adapters.

Your radiator installation is complete, and we can now move-on to the water-block installation.