Blodgett HV-50 - Manual (Page 17)

15
Operation
MenuSelect™ Control
Programming a Product Recipe
NOTE: The control can hold 99 recipes. Each recipe may
have up to 6 cooking stages.
1. Turn the dial to highlight the name of the product to
be programmed. Press the center of the dial to select
the product.
2. The display reads PRODUCT NAME: STAGE 1.
Press the center of the dial to select the stage.
3. Rotate the dial, or use the alpha/numeric keypad to
enter the desired bake time. Press the center of the
dial to set the bake time.
NOTE: Time is set in one minute increments using
the dial. To set time in less than one minute
increments use the alpha/numeric keypad.
4. Rotate the dial to select the desired cooking mode.
Choose from Hydro or Hot Air. Press the center of the
dial to set the cook mode.
If Hydro is selected, rotate the dial, or use the alpha/
numeric keypad to enter the desired percentage of
moisture.
5. Rotate the dial, or use the alpha/numeric keypad to
enter the desired cook temperature. Press the center
of the dial to set the bake temperature.
NOTE: Temperature is set in 5 degree increments
using the dial. To set time in less than 5 de-
gree increments use the alpha/numeric key-
pad.
6. Rotate the dial to select the desired fan speed.
Choose from gentle, low, high or turbo. Press the
center of the dial to set the fan speed.
7. Rotate the dial to select the fan rotation cycle. Choose
between manual or auto.
NOTE: This is the length of time the fan will rotate in
one direction before reversing.
If manual is selected, rotate the dial or use the alpha/
numeric keypad to enter the desired fan cycle. Press
the dial to set the fan cycle.
If auto is selected, the program will use the default
fan cycle setting. The default is set through the Man-
ager Programming. See page 18.
8. Rotate the dial to set the vent position. Choose be-
tween OPEN or CLOSE. Press the center of the dial
to set the vent position.
9. Use the dial to scroll down to PRODUCT NAME:
STAGE 2. Press the center of the dial to select stage
2.
10. Repeat steps 2-9 for all remaining stages.
11. When all stages have been programmed, press the
PROGRAM KEY (13). To save the programming, use
the dial to scroll to YES. Press the center of the dial.
The control exits the program mode.
USING THE USB PORT
1. With the power on, remove the cover of the USB port
(20) and insert the USB drive.
2. Press the MAINTENANCE KEY (15).
3. Turn the dial to highlight MANAGER PROGRAM.
Press the center of the dial to select.
4. Turn the dial to highlight either COPY RECIPE FROM
USB or COPY RECIPE TO USB, then press the cen-
ter of the dial to select.
5. When the transfer is complete, press any key to re-
turn to the menu.
6. Turn the dial to highlight EXIT. Press the center of
the dial to select. The display returns to the previous
menu.
7. Turn the dial to highlight EXIT. Press the center of the
dial to select.